Bit of wiring and Problem handbrake

Trying to fit the original ford wiring loom in was tricky as it was so big and long, but with a lot of electrical tape and cable ties it was in well enough to start building around it. A lot of the wiring would be cut out later on as it wasn't needed in my 2b.

You can just about see the handbrake arrangement in this photo. The problem is that where the bracket for the cable is welded it is hard up against the dion tube holding the diff leaving no reeom the get the cable through. You'll see later in the blog how I eventually solved this design flaw.

Throughout this build I didn't use the supplied "Instruction tapes" as they were pretty useless. Instead I followed other blogs and advice from RHOCAR and other 2b owners. This is what makes every 2b different from others.